Earlier the practice of wearing powerlifting belts was limited to Olympic powerlifting and weightlifting. However, these days the recreational lifters too wear them. Many believe this powerlifting equipment helps in enhancing their performance, more than providing protection. It provides extra support for lifting heavy weights. They are designed for increasing intra-abdominal pressure to stabilize the entire midsection of a lifter. And this is where the importance of the design of your belt lies. In general, the gym belts come with wider back and skinny up front. However, such powerlifting belts can hardly cover enough abdominal surface area for providing the support that a lifter needs while performing. In fact, a powerlifting belt that is completely wide is what you need for squat, deadlift, and other lifts that challenge your core strength. Such a belt will support your obliques and abdominals. Powerlifting belts come in three basic designs – prong, lever, and ratchet. Prong powerlifting belts are far less expensive than ratchet and much more flexible than lever belts. In fact, you need a screwdriver to disassemble a level belt to adjust its size. Moreover, prong belts are less cumbersome than ratchet belts. All these powerlifting belts are available in two basic thicknesses i.e. 10mm and 13mm. The 10mm belts require less break-in, whereas the 13mm belts are tougher. best powerlifting belt
If you are planning to settle on a prong belts, go for a single prong, as it is easier to tighten than a double prong belt. And those who are looking for a powerlifting belt for deadlifting, it is recommended to opt for a thinner belt. Such designs will make it easier to get down to your bar. Many lifters wear powerlifting belt backwards to avoid the buckle getting in the way. Go for a narrower powerlifting belt, which can hold the bench shirt in place, allowing you to arch properly. It is very simple to wear the belt. Make sure the powerlifting belt fits perfectly around the small of your back. The buckle should cover the lower abdominals. Another tip is to wear this powerlifting equipment low, though it must not get jammed in your hip’s crease while deadlifting or squatting. Also, don’t wear your belt all the way tight, as you will have to expand your abs while lifting. Another fact that you need to consider while wearing a powerlifting belt – never wear them for every exercise. Let you abdominal muscles and back function normally. You can put it on beforehand while doing squatting and speed squatting, as you need to practice filling up the belt. Also, you don’t need to wear a belt for assistance work. And to take complete advantage of your powerlifting belt, you can use the valsalva maneuver. This is a simple process where you need to take a big gulp of air directly into your belly and exhale the air force by closing your throat. The pressure pushes your belly into the powerlifting belt, increasing the pressure around your midsection. This, in turn, will force your lower back to arch. However, you need to push your abs out for getting the pressure.